This is the LOWRIDER dust boot for the i2R and Axiom Iconic series. 

The LOWRIDER dust boot is a non-reciprocating, height adjustable dust boot that allows the user to keep the brush assembly of the dust boot at a static height just touching the work surface, independent of the the spindle.  You can now use those short end mills or vcarve bits without smashing down on the brush of a traditional dust boot, and causing missed steps on the Z stepper motor. 

The LOWRIDER can also have the dust collector assembly swapped out in seconds for an accessory mount such as a laser. 

Click on this youtube link for a quick video demonstrating this - https://youtu.be/c6PnD13atAw.

Youtube clip demonstrating the dust boot during a drill/bore operation - https://youtu.be/rGuGhUQZYU0

Overview of the LOWRIDER dust boot - https://youtu.be/Y12Lj3lY_n0

Accessory mount plate for the OPT 150watt & 6-watt lasers is available now.

• The dust port on the bottom brush assembly is angled towards the end mill for maximum effectiveness.
• The brush is user replaceable, and can easily be replaced without using glue or adhesives.  Just slide it on or off!
• The removable brush assembly is held in place by a rear hook assembly and 8 rare-earth magnets in the front for the ultimate in stability.  Rock solid attachment.
• Integrates seamlessly with the design of the machine.
• Comes with fully enclosed brush assembly - 2 inch brush height.
  
  • 3 inch available by request if desired.
• Available in Black/Red.  Some additional colors available by request.